5 Essential Elements For accurate 2520 load data

I will fall again several grains and perform up and find out what happens .I have and use alot in the 2400.Bought 2 from the aged Enfields Number one MKIII's and want to consider it in them also,haven't loaded for them nonetheless but beeing a rifle bored out to 410ga it might be that I could bump them up a little bit more,a regular 410 shotshell wont suit the chambers on these And that i must fireform for them independently,the sights are riveted so I must control the load to acquire them to shoot appropriate.



Don't find out about 410, but, I bumped into exactly the same point with Alliant e3. I commenced shooting it in .40 S&W and even despatched test loads to Alliant for stress tests with very good success.

Never blend any two powders despite variety, model, or source. Under no circumstances substitute any smokeless powder for Black Powder or its substitute.

I'm however loading the old style Winchesters though, haven't had to resort towards the HS yet. Found a Offer on about 15 flats of them a couple of several years ago, and bought all of them. I have only been using the new ones for competition, but I will be jogging out before long.

LilGun burns up my hulls also speedy as does Alliant 410. I have also tried nearly all the things else. Will not recall my gripes Together with the Other individuals, but I've been making use of H110 quite a while and often are already delighted with it.

I wound up putting in a plastic powder baffle to reduce very same. I maintain a can of bottled air helpful that will help retain down buildup at the base when reloading.




Winchester 296 and Hodgdon a hundred and ten are exactly the same powder with a different label. You may get by just wonderful without having at any time weighing a shot demand or reaming a bushing; Practically not one person does both.

So If the not about to ream the shot bushing and just Allow it toss 214grs of shot, then up the powder bushing to your .three hundred" ID bushing within the HS loads. This click this link now extra minor bit of powder will give the shell the desired volume to fill it absolutely, Therefore the shot doesn't rattle after crimp.

This is certainly an more mature thread, you might not get a reaction, and will be reviving an outdated thread. You should take into consideration developing a new thread.

I positive hope it works as I just purchased eight kilos of it soon after not being able to get Lil'gun. And relating to this chilly weather conditions challenge, we shoot skeet in Boulder Jct, WI Sun/Wed fifty two weeks a 12 months.

This is an older thread, you may not receive a response, and will be reviving an old thread. You should contemplate developing a new thread.

Your rammer tube may very well be set much too very low. I have not loaded .410, but I think the thirty lb. you should move the indicator is a lot of for any .410 wad. Try ramming a wad Along with the clamp free and find out In case the rammer tube moves up. If it does, attempt a crimp. If which is much too high, decrease and champ the tube about fifty percent way.




Summary: Accurate 1680 Powder is often a high-general performance choice for small caliber rifles and pistols, providing constant efficiency and accuracy for discerning marksmen.

They are telling it like it reall is. From the 410, there isn't any much better propellant than H110/W296. It can get you the highest velocities, with important link pressures within purpose and is also significantly easier on cases than other powders and Alliant 410 is especially hard on AA HS circumstances.